THREADED PROBE SERIES
HPT SERIES THREADED PROBES
Similar to the HPC Series the threaded probes allow mounting into a drill and tapped hole or bracket where more limited access is available. The probe is held in place with a mating nut (optional) and may be rotated for fine axial positioning.
STYLES
HPT-40
HPT-75
HPT-150
HPT-375
HPT-500
           
Sensor OD
0.040 (1.02)
0.075 (1.91)
0.150 (3.81)
0.375 (9.53)
0.500 (12.70)
Case OD
0.187 (4.75)
0.250 (6.35)
0.375 (9.53)
0.750 (19.05)
1.000 (25.40)
Linear Range
0.020 (0.51)
0.050 (1.27)
0.100 (2.54)
0.250 (6.35)
0.325 (8.26)
Thread Size
10 - 32 UNF
1/4 - 28 UNF
3/8 - 24 INF
3/4 - 16 UNF
1 - 12 UNF
• Range specified in inches (millimeters)
• Thread size defined as first number = diameter (3/8); second number threads per inch (24)
• Optional metric sizes available (Consult Factory)
Rule.gif
NOTES:
  1. The guard element is driven with an electronic voltage 2 to 20 Volts P - P maximum and must not be grounded.
  2. -D dip coatings also prevent the driver, sensor and guard elements from being accidentally earth grounded or shorted. (not available on "V" and "S" series probes)
  3. Range values tested with 5 ft. (1.524 meters) of Capacitec L2 cable.
  4. Range and signal to noise ratio will be degraded by longer cable lengths.
  5. A 20 point archived calibration record of voltage output versus nominal displacement is provided standard with every probe.
  6. Sensor must be calibrated with final length of cable for stated results.
  7. All components are electronically isolated from each other by greater than 20 megohms of leakage resistance (at room temperature) for best operation with the instrumentation.
FREE counter and Web statistics from sitetracker.com